Previous Topic: install_base Command—Run Installation ScriptNext Topic: Configure Post-Installation Settings


How the install_base Script Works

The install_base script performs the following steps:

  1. Asks you whether you want to change the default installation directory.
  2. Displays the installation options you supplied and asks that you to confirm that you want to continue with the installation.
  3. Extracts the data from the tar.Z file into the installation location (default or as specified by target_dir).
  4. Different platforms cause different actions:
  5. Allocates, initializes, and formats the CA ControlMinder database and builds the seos.ini file. The database files are placed in the ACInstallDir/seosdb directory (ACInstallDir is the CA ControlMinder installation directory.)
  6. Determines if the machine is NIS+
  7. Under supported 32-bit platforms Sun Solaris, IBM AIX, HP‑UX, and Linux, the script determines if the machine is running under NIS or DNS (using caching). If it is, the script automatically creates a lookaside database and sets two tokens in the [seosd] section of the seos.ini file to yes: under_NIS_server and use_lookaside.

    Note: On other platforms the script prompts you for whether you want to install a lookaside database and for the target installation directory.

  8. Prompts you for the following additional information: (You can modify these settings any time after installation.)

If you want to:

Respond with:

Allow your database to be subscribed to a specific PMDB

The name of the PMDB in the format pmd_name@hostname

Prevent your database from being subscribed to any PMDB (at least until you specify otherwise)

The Enter key.

A third response, _NO_MASTER_ , allows your database to be subscribed to any PMDB. However, this can be a dangerous response, because it removes the selection of the PMDB from your control.