Previous Topic: Suppression and Summarization RulesNext Topic: How Configuration Settings Affect the Report Agent

Integration Guide › Integrating with CA User Activity Reporting › How to Set Up CA User Activity Reporting for CA ControlMinder › Connector Configuration Requirements

Connector Configuration Requirements

Once you create the connector and specify the connector details, you can configure the connector. This topic describes the settings that you must configure on the Connector Configuration page of the Connector Creation wizard to begin event collection.

Note: For information about other optional settings that let you customize your event collection, see the CA User Activity Reporting Administration Guide and the Online Help.

TIBCO Server

Specifies the host name or IP address of the Message Queue (TIBCO server) in the following format:

Protocol://server IP or name:Port number

The Message Queue is installed on CA ControlMinder Enterprise Management.

The port values and communication method are the default ports that CA ControlMinder Enterprise Management uses. If you configured different values after installing CA ControlMinder Enterprise Management, use that port and communication method values.

TIBCO User

Specifies the user name for Message Queue authentication. CA ControlMinder defines a default user named "reportserver".

TIBCO Password

Specifies the password for Message Queue authentication. Enter the password that you defined in the "Communication Password" dialog when you installed CA ControlMinder Enterprise Management.

Event Log Name

Specifies the log name for the event source.

Accept the default, "CA ControlMinder".

PollInterval

Specifies the number of seconds the agent waits before polling for events when the Message Queue has become unavailable or disconnected.

SourceName

Specifies the identifier for the Message Queue queue.

Accept the default, "queue_audit".

TIBCO Queue

Specifies the name of the Message Queue queue from which the log sensor is to read messages (events).

Accept the default, "queue/audit".

Number of Collection threads

Specifies the number of threads the log sensor spawns to read Message Queue messages.

You should consider the number of events in the Message Queue queue and the CPU of the CA User Activity Reporting agent system when you adjust this value.

Limits: The minimum value is 1. The maximum number of threads that the log sensor can spawn is 20.