Server Management › Test Servers

Test Servers

You can test communications between CA Configuration Automation and one or more servers using the Test Servers operation. The operation attempts to contact the selected servers and the CA Configuration Automation Agent if installed on the target server.

To test server communication

1. Click the Management link, then the Servers tab.

   The Servers tab page appears.

2. Click the check box next to one or more servers you want to test, then select Server Actions, Test Servers from the Select Actions drop‑down list.

   The Test Servers dialog appears and displays the following results in the Server Test Results table:

   Servers

   Specifies the names of the server selected for the test.

   Access Mode

   Specifies the mode used to access the server (WMI, SSH, and so on).

   Ping Test

   Displays a check mark if the server responded to being pinged or an X if there was no response.

   Server Access Test

   Displays a check mark if the server could be accessed by the test or an X if it could not be accessed.