Event Notification Facility › CAIENF/DB2 Operation › Disable or Enable the Installation of CAIENF/DB2 Intercepts

Previous Topic: Configure CAIENF/DB2 to Install Intercepts

Next Topic: Activation of CA Products (CAIENF/DB2)

Disable or Enable the Installation of CAIENF/DB2 Intercepts

You can disable or enable the installation of CAIENF/DB2 intercepts in DB2 subsystems that may become active in the future. The operation does not affect currently active DB2 subsystems.

To disable future installation of the intercepts, issue the following command:

ENF MODE(DB2,NONE)

The next time a DB2 subsystem starts, no intercept is installed.

To enable the installation of the intercepts again, enter the following command:

ENF MODE(DB2,ON)

CAIENF/DB2 resumes installing intercepts in DB2 subsystems as they start.