Event Notification Facility › CAIENF/DB2 Operation › Configure CAIENF/DB2 to Install Intercepts

Previous Topic: CAIENF/DB2 Operation

Next Topic: Disable or Enable the Installation of CAIENF/DB2 Intercepts

Configure CAIENF/DB2 to Install Intercepts

To configure CAIENF/DB2 to install intercepts in DB2 subsystems, update the CAIENF control option member with the following CAIENF/DB2 control options:

MODE(DB2,ON)
DB2REL

DB2REL tells CAIENF to load the CASR230 program module into CSA. The module supports all DB2 levels.

Note: For information about CAIENF/DB2 control options, see the Reference Guide.

To ensure that the CAIENF/DB2 intercepts are installed in your DB2 subsystems, issue the START DB2 commands from the CAIENF auto commands member so that the DB2 subsystems start after CAIENF becomes active.