This command displays a summary of your current network, as seen from the node executing the command.
goalNET STATus
Example
---------------------- CA‑GSS/ISERVE Control Panel ------- ROW 1 TO 19 OF 23 ==> goalnet status => PAGE Target node: * ssid: * Host node: B1EWF ssid EWF ============================================================================== Status for node: B1EWF ACB: OPEN Restart: AUTO Node Status Type SYSNAME SMF P I JESNODE B1MAIN ACTIVE GSS z/OSB1 B1 I z/OSB1 B1TECH DOW GSS z/OSB1 B1EWF SELF GSS z/OSB1 B1 z/OSB1 B1EWF2 DOWN GSS z/OSB1 B1TRAC ACTIVE GSS z/OSB1 B1 z/OSB1 B1EXP INACTIVE GSS z/OSB1 B1IV41 ACTIVE GSS z/OSB1 B1 I B2MAIN DOWN GSS z/OSB2 B2TECH DOWN GSS z/OSB2 B2EWF INACTIVE GSS z/OSB2 B2EWF2 INACTIVE GSS z/OSB2 B2PC INACTIVE GSS z/OSB2 B2TRAC ACTIVE GSS z/OSB2 B2 z/OSB2 B2EXPL INACTIVE GSS z/OSB2 CORS6000 INACTIVE GMF RS6000
Node name as defined by the installation.
The current communications status of the node:
Last (or current) attempt at communication was successful and no notification of failure has been received from VTAM. This node is available for communication.
No attempt has been made to communicate with this node nor has a communication request been received from the node. An incoming request changes the status to ACTIVE.
Last attempt at communicating with this node failed. No further attempt is made to use this node until a START command is issued against it or until a request is received from the node. An incoming request changes the status to ACTIVE.
A STOP command has been issued against this node (executed from this ISERVE). Until a START command is issued from this ISERVE no further communications is made to, or accepted from, this node.
The node has been successfully prepared for communications, but none have yet been attempted. An incoming or outgoing request changes the status to ACTIVE.
While in an ACTIVE state, this node disconnected due to a local VTAM failure (VTAM terminated or application ID VARYed inactive). After access to VTAM is restored, a RESTART command attempts to restart this node. If your GoalNet is configured to do so, a RESTART command is automatically executed immediately following VTAM initialization.
Indicates the node where the STATUS command was executed.
Type of node as defined.
GSS
Assigned to CA‑GSS for z/OS.
GRS system name where the node is executing.
Note: Because this value is determined from initialization parameters, it does not always accurately reflect the real system name of the remote node.
SMF ID of the system where the node is executing.
Note: Because this value is determined from initialization parameters, it does not always accurately reflect the real SMF ID of the remote node.
If not blank, this indicates that this node is a CA SYSVIEW Performance Management focal point. CA SYSVIEW Performance Management consolidates its activities in a single ISERVE address space per z/OS image.
If not blank, this indicates that this node is a CA Insight Database Performance Monitor for DB2 for z/OS focal point. CA Insight Database Performance Monitor for DB2 for z/OS consolidates its activities in a single ISERVE address space per z/OS image.
Name that JES2 uses to route NJE requests.
Note: Because this value is determined from initialization parameters, it does not always accurately reflect the actual JES2 NJE node name.
The GOALNET command can be abbreviated to GN, NET, or GNET.
|
Copyright © 2014 CA Technologies.
All rights reserved.
|
|