Test the Installation

CA Global SubSystem Configuration › Test the Installation

Test the Installation

The basic installation process is complete. You can verify that CA‑GSS has been installed correctly.

Follow these steps:

Start CA-GSS.
Enter the following command from the operator console:
```
START GSSA
```
Initialization proceeds rapidly; when it is complete, the following message is displayed:
```
SRV220 Release 14.00.00 BASE: Initialization Complete (ssid)
```
ssid represents the subsystem ID you selected for ISERVE.
Test CA-GSS.
- Invoke the CA‑GSS/ISERVE Control Panel by issuing the following command from an ISPF panel:
```
	TSO EX 'CAI.CAW0CLS0(GSSOPER)'
```
- Execute the Installation Verification Program (IVP) by issuing the following command from the CA‑GSS/ISERVE Control Panel:
```
	IVP [PRINT [TO userid [AT node]]]
```
  If you omit the text in brackets, output is produced on the console, verifying the operation of CA‑GSS. Optionally, you can specify that a complete report is printed. If the PRINT option is specified, you can also specify the user ID and node where the printed listing is routed.
- Use the PF3 key to return to your ISPF panel.
Test the IMOD Editor.
- Invoke the IMOD editor by issuing the following command from an ISPF panel:
```
	TSO EX 'CAI.CAW0CLS0(GSSEDIT)'
```
- Select the SAMPLIB ISET by specifying S next to its name. Then select the $$$VERSION member by specifying S next to its name.
- Verify that the correct version of CA‑GSS is specified in the $$$VERSION member. (0208mm.)
  When the version is correct, use the PF3 key to go back to the SAMPLIB ISET display.
- Compile the $$$VERSION member by specifying G next to its name.
  To verify that the compile worked, look for an IMOD LOADED message in the upper right corner of the panel.
- Use the PF3 key to back out of your ISPF session.
Stop CA-GSS.
Terminate CA‑GSS properly by entering one of the following commands from an operator console:
```
STOP GSSA
P GSSA
F GSSA, STOP
```
If CA‑GSS does not terminate within a few seconds, enter the following command:
```
F GSSA, STOP FORCE
```
If CA‑GSS still does not terminate, cancel the address space and inspect the JESLOG and ISRVLOG listings for diagnostic messages.