Start the Communications Server with VTAM

To use a VTAM protocol only, issue the ATTACH command as follows:

ATTACH COMMSERVER ACBNAME(name) CONTYPE(luvalue)

name: The applid that identifies CA-L-Serv to VTAM on this system. Instructions on setting the value of applid are provided during installation.
luvalue: Either LU0 (for LU 0) or LU62 (for LU 6.2). If CONTYPE is not specified, it defaults to LU0.

To use both XCF and VTAM, issue the ATTACH command as follows:

ATTACH COMMSERVER ACBNAME(name) CONTYPE(luvalue) XCF(YES)

name

Defines the applid that identifies CA-L-Serv to VTAM on this system.

luvalue

Either LU0 (for LU 0) or LU62 (for LU 6.2); LU0 is used by default.