Identity Management Service › Getting Started with Identity Management › How to Set Up On-Premise Provisioning › Install CA IAM Connector Server

Install CA IAM Connector Server

The CA IAM Connector Server includes connectors for all of the endpoints that are supported at the time of the release.

When you install CA IAM Connector Server, be sure to record the values you enter. The port name, password, and URL are required in other parts of the process.

Note: This procedure assumes that you do not already have a local instance of CA IAM Connector Server installed. If you have installed it as part of an Identity Management installation, the default username is set to "admin".

Follow these steps:

1. Check the time settings for your on-premise Connector Server host. They must match the setting information that you received from the System Administrator for the two servers to connect successfully.

   Note: The cloud-based and on-premise Connector Server time zones need not match, only the settings. For example, daylight savings time must be enabled on both.

2. Download CA IAM Connector Server from support.ca.com, and launch the installer.
3. Select the C++ connector option you want, depending on your environment.
4. Clear the "Register this installation with a Provisioning Server" checkbox if it is selected. This setting is not required for an on-premise installation.
5. On the Cloud Connector Server screen, enter the following information:
   • Server URL - The URL of the cloud-based CA IAM Connector Server messaging interface, for example: https://hosting.cloudminder.com/gateway/request/tenant/mytenant/. The System Administrator provides the URL information.
   • Tenant Name
   • Tenant Host ID - Optional identification for an environment with multiple on-premise server installations.
   • Username - The user name that the System Administrator created for this tenant.
   • Password - The password that the System Administrator created for this tenant.

   Note: To connect to a cloud-based Connector Server, enter details in this step. The details are required for the installer to create a key pair and self-signed certificate. If for some reason you cannot enter details on initial installation, rerun the installer and add details before completing the connection.

6. Enter the admin password on the Connector Server Configuration screen, and accept the default LDAP port values.

   Note: If you install multiple connector servers, be sure to set the same password for each. This practice avoids a password synch issue.

7. On the Port Configuration screen, accept the default values.
8. Enter HTTP Proxy credentials if your environment uses an HTTP proxy.
9. Complete the wizard. You can install multiple connector servers in your environment, depending on your needs.