Configuring Products › Managing Configurations › Select Functions and Options

Select Functions and Options

After you have defined your configuration, you select the functions and associated options you want to use for the configuration. Default options in this step are selected for you. You can clear options that are not required.

Follow these steps:

1. On the Select Functions and Options step, select the product functions and options for each function that you want to configure:

   Functions

   Select functions to use for your configuration, and the associated options are enabled. The selection of one function may disable other functions. A required function that is selected and disabled cannot be deselected. You can clear a default function that has been selected.

   Options

   Select the options you want to use for each selected function. The selection of other options may enable or disable other options.

   Note: For disabled options, you can click the icon in the Details column for information about why this option is disabled.

2. Use the following buttons to control and navigate through the wizard:

   Save

   Saves your changes.

   Note: This button saves your selections but does not close the wizard.

   Next

   Continues to the next step and saves your selections.

   Note: This button is disabled in this step until at least one option is selected.

   Exit

   Exits the wizard without building the configuration.

   Note: If you have not yet built the configuration, you can exit and resume the wizard at a later time. If you have built the configuration, you can edit the configuration.