Previous Topic: Deployment FTP LocationsNext Topic: Add FTP Locations

Setting Up System Registry › Network Locations › Set SCS Address Space Location

Set SCS Address Space Location

Connect the SCS address space to a system in your system registry.

You can connect the SCS address space to a system of the following types:

Follow these steps:

  1. Click the System Registry tab, and select Non-Sysplex Systems, Sysplexes, or Shared DASD Clusters from the tree on the left side.

    Information about the systems that you selected appears on the right side.

  2. Select the system that you want to set the address location for.

    Detailed information about the system appears on the right side.

  3. Click the Network Locations subtab, and in the SCS Address Space Location area, complete the following fields and click Save:
    Host Name

    Specify the TCP/IP host name or IP address of the target system.

    Note: The TCP/IP host name is not the SMF ID.

    Limits: 255 characters

    TCP Port Number

    Specify the port number for the SCS address space.

    Limits: 65535

    Default: 49152

    TCP Connection Retry Count

    Specify the number of times an operation is retried when the initial attempt is unsuccessful. These operations are send/receive transactions that target the SCS address space. Not all types of transactions can be retried, and those transactions that can, are determined on a case-by-case basis as they are implemented. Setting this field to 0 means that no retries are performed.

    Limits: 0 to 99

    Default: 15

    TCP Connection Timeout Value in Seconds

    Specify the maximum number of seconds to wait for a response on each send of a transaction request. If a communication attempt times out, the transaction can be retried. Until the maximum number of retries has not been reached, a retry occurs. If no more retries are possible, a message appears indicating a network timeout has occurred. Each retry uses the same timeout value as the initial transaction.

    Limits: 1 to 999

    Default: 10

    The new SCS address space location information is saved.

  4. Click Status to verify that the address space is working.

    The dialog that displays information about the SCS address space opens.