SCS Address Space Administration › Operator Communications Interface › SCS Address Space Operator Commands › STOP Command—Stop the SCS Address Space

STOP Command—Stop the SCS Address Space

The STOP command initiates the normal termination of the SCS address space. You can enter STOP or the P abbreviation. Provide CONTROL authority to the SAF OPERCMDS class resource named CAMSMSCS.STOP to use this command.

To authorize, use one of the following methods, depending on how the SCS address space was started:

• If the SCS address space was started as a started task, provide UPDATE authority to the SAF OPERCMDS class resource named MVS.STOP.STC.procname.
• If the SCS address space was started as an initiated job, provide UPDATE authority to the SAF OPERCMDS class resource named MVS.STOP.JOB.jobname.

This command has the following format:

stoP jobname

jobname

Specifies the SCS address space started task or initiated job name. The common name is MSMCPROC.

Example: Stop the SCS Address Space

This example identifies how to stop the SCS address space using the STOP command.

P MSMCPROC