SCS Address Space Administration › Operator Communications Interface › SCS Address Space Operator Commands › MODIFY Command—Modify the SCS Address Space › MODIFY STOP Command—Initiate Normal Termination of the SCS Address Space

MODIFY STOP Command—Initiate Normal Termination of the SCS Address Space

The MODIFY STOP command is used to initiate the normal termination of the SCS address space. You can enter MODIFY or the F abbreviation. Provide CONTROL authority to the SAF OPERCMDS class resource named CAMSMSCS.STOP to use this command.

Note: The results of the STOP command and the MODIFY STOP command are identical.

To authorize, use one of the following methods, depending on how the SCS address space was started:

• If the SCS address space was started as a started task, provide UPDATE authority to the SAF OPERCMDS class resource named MVS.MODIFY.STC.procname.
• If the SCS address space was started as an initiated job, provide UPDATE authority to the SAF OPERCMDS class resource named MVS.MODIFY.JOB.jobname.

This command has the following format:

modiFy jobname,STOP

jobname

Specifies the SCS address space started task or initiated job name. The common name is MSMCPROC.

Example: Modify the SCS Address Space using MODIFY STOP command

This example identifies how to modify the SCS address space using the MODIFY STOP command.

F MSMCPROC,STOP