SCS Address Space Administration › Operator Communications Interface › SCS Address Space Operator Commands › MODIFY Command—Modify the SCS Address Space › MODIFY ABEND Command—Initiate Abnormal Termination of the SCS Address Space

MODIFY ABEND Command—Initiate Abnormal Termination of the SCS Address Space

The MODIFY ABEND command is used to initiate the abnormal termination of the SCS address space. You can enter MODIFY or the F abbreviation. Provide CONTROL authority to the SAF OPERCMDS class resource named CAMSMSCS.ABEND to use this command.

To authorize, use one of the following methods, depending on how the SCS address space was started:

• If the SCS address space was started as a started task, provide UPDATE authority to the SAF OPERCMDS class resource named MVS.MODIFY.STC.procname
• If the SCS address space was started as an initiated job, provide UPDATE authority to the SAF OPERCMDS class resource named MVS.MODIFY.JOB.jobname

This command has the following format:

modiFy jobname,ABEND

jobname

Specifies the SCS address space started task or initiated job name. The name is commonly MSMCPROC.

Example: Modify the SCS Address Space using MODIFY ABEND command

This example identifies how to modify the SCS address space using the MODIFY ABEND command.

F MSMCPROC,ABEND