Previous Topic: Apply Preventative MaintenanceNext Topic: Customize Members

Unified Install Process › Run the Staging Jobs

Run the Staging Jobs

The staging jobs copy the required job, procedure, parameter, and configuration members from the installation libraries into staging libraries. The staging jobs can be found in the LDAP JCL library (<instlib_hlq>.CHRSEC.LDAP.CDT9JCL) created by the previous steps. Choose the appropriate staging job for your system:

STAG3DCA

Copies members needed for CA ACF2 systems installing components compatible with CA Chorus r3.0. Uses role-based rules for the security administration jobs.

STAG3DCU

Copies members needed for CA ACF2 systems installing components compatible with CA Chorus r3.0. Uses UIDSTRING-based rules for the security administration jobs.

Note: The security administration jobs contain UIDSTRING-based rules that require manual edits during the customization phase of the process. All manual steps are described in the AREADME file and in the jobs themselves.

STAG3DCT

Copies members needed for CA Top Secret systems installing components compatible with CA Chorus r3.0.

Follow these steps:

  1. Modify the job card according to site standards.
  2. Edit the following variables:
    INSTLIB_HLQ

    HLQ of the libraries that were created when the unified install process ESD file was installed. This value must match the value that was used for the “instlib_hlq” variable in the UNZIPJCL job

    STAGELIB_HLQ

    HLQ of the libraries that are created by this job to hold copies of all members needed for the configuration process. It is acceptable to use the same value for all of the high level qualifiers.

    STAGELIB_VOL

    Volume used for stage libraries. If using SMS, replace the 'VOL=SER=STAGELIB_VOL' statement with the appropriate SMS statement.

    STAGELIB_UNIT

    Unit used for stage libraries.

  3. Run the staging job.

    The staging libraries are created.