Use this worksheet to record the values that are specified for the CA Chorus ports. These values are specified during the CA Chorus configuration:
Specifies the beginning port assignment for the 12 consecutive port values that are required by the CA Chorus JBoss server started task (CHORJBOS by default). There is not a default for the 12 consecutive ports.
Use the TEIID_PORT setting in the ENVETJ member of your_chorus_hlq.CETJOPTN to specify the ports.
Important! For various discipline configuration tasks, you may need to know the CA Chorus port.
Port number that is used to access JBoss. Use the value of JBOSS_HTTP_PORT in CETJOPTN(ENVETJ). By default, this value is the TEIID_PORT value +4 for HTTP. For SSL, use the value of JBOSS_SSL_PORT in CETJOPTN(ENVETJ). By default, the value is the TEIID_PORT value + 10.
Specifies the TSF region port values for the CHORTSF started task. Three ports are required.
Use the TSFPARMS member in your_chorus_hlq.CETJOPTN to set the three TSF region ports.
Specifies the TSF remote relay port values for the CHORTSFR started task. Two ports are required.
Use the TSFRPRMS member in your_chorus_hlq.CETJOPTN to set the two TSF remote ports.
Note: The TSF Remote Relay uses a third port for monitoring the connection from the TSF relay to the TCP/IP stack. By default, this port is dynamically allocated. To specify this port value instead of having it dynamically allocated, edit the MONPORT parameter in the TSFRPRMS member in your_chorus_hlq.CETJOPTN.
Specifies a display port number in the CHORWEBX started task and in CETJOPTN(ENVE4H) for the -DDISPLAY variable. One port is required.
One of the last steps after configuring the post CA Chorus for Storage Management is to start the CHORWEBX started task so that the Quick Link Storage Management interface can create charts. Assign this port within TCP/IP to the CHORWEBX task. The CHORWEBX task is located in CE4HJCL(E4HWEBX).
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|