How to Promote a Test System › Verify the Installation and Configuration

Verify the Installation and Configuration

Use this procedure to confirm that you have successfully completed the CA Chorus installation and configuration procedures. If at any point you do not see the expected result, confirm that you have completed the configuration steps as documented. If you cannot identify the issue, contact CA Support.

Note: In addition to this procedure, for CA Chorus for Security and Compliance Management, you can run ETJIVP01 in chorussec_custom_hlq.CETJJCL to verify the discipline installation.

Follow these steps:

1. Confirm that the applicable back-end products are up and running.
2. Open a supported browser.
3. Enter the JBoss host name and port in the URL using one of the following formats:

   http://jbosshostname:httpconnectorport/Chorus
   https://jbosshostname:httpsconnectorport/Chorus
   

   Note: If you ran ETJI0110 in chorus_runtime_hlq.CETJJCL to enable HTTPS, use the previously shown HTTPS format to specify the host name and port.

   jbosshostname

   Host name of the system where JBoss is running. Use the value of the TEIID_MACHINE environment variable in CETJOPTN(ENVETJ).

   httpconnectorport

   Port number that is used to access JBoss. Use the value of JBOSS_HTTP_PORT in CETJOPTN(ENVETJ). By default, this value is the TEIID_PORT value +4 for HTTP. For SSL, use the value of JBOSS_SSL_PORT in CETJOPTN(ENVETJ). By default, the value is the TEIID_PORT value + 10.

   Press Enter.

   The CA Chorus login page opens.

   Note: If HTTPS is enabled, follow the prompts to add the URL as a trusted site.

4. Log in to the product.

   The CA Chorus interface opens.

5. Add the Investigator module to your dashboard from the Module Library, and click Start New Investigation.

   The Investigator opens.

6. Select your discipline from the drop-down list in the upper left corner.
7. Confirm that the table in the Investigator displays data.

   You have confirmed that you can log in to CA Chorus and back-end data appears in the user interface.

8. (Optional) Open the Quick Links module, and select a link.

   You have confirmed that the quick links configuration is accurate.

   CA Chorus and the applicable disciplines are installed, deployed, and configured.