Using AS/400 Manager › Managing Multiple AS/400 Systems › Setting Up AS/400 to Connect to Multiple Stand-alone Systems

Setting Up AS/400 to Connect to Multiple Stand-alone Systems

To set up AS/400 Manager to connect to multiple stand-alone systems, perform the following procedures.

• Set up AS/400 for communication with AS/400 Manager.
• Set up the workstation to communicate with the AS/400 system.
• Customize CA Automation Point files.
• Configure AS/400 Manager.

Note: The procedures you follow here parallel the ones you use to install AS/400 Manager using the sample configuration procedure.

Repeat the steps in these procedures for each system that you want to add, using new session names, file names, short names, and so on for each system.