CA AuthMinder UNIX Installation Guide › Upgrading to Release 7.1 › Upgrading to 7.1 › Reinstalling AuthMinder › Reinstalling AuthMinder on a Single System

Reinstalling AuthMinder on a Single System

Perform the tasks described in the following sections to reinstall AuthMinder on a single system:

Important! The information given in these sections apply to both a fresh installation of AuthMinder and an upgrade of an existing AuthMinder installation. Some of the steps mentioned in these sections do not apply in an upgrade scenario. For example, MySQL-related steps do not apply because MySQL is supported only from release 7.1 onward.

Important! Use the database that you had migrated earlier during the upgrade operation. In addition, install AuthMinder at the same location where the older release was installed. If you install in a different location, the AuthMinder Server will not start.

1. Performing Complete Installation
2. Verifying the Database Setup
3. Preparing Your Application Server
4. Deploying Administration Console
5. Verifying the Administration Console
6. Logging In to Administration Console
7. Starting WebFort Server
8. Verifying the Installation

   Note: If there are any warnings during Server startup or while verifying the installation, and if your transactions fail, then the upgrade has not been performed successfully. You can revert to your initial setup by following the steps listed in "(In Error Scenario Only) Reverting to Your Initial Setup" in the CA AuthMinder Installation and Deployment Guide for UNIX Platforms.

9. Deploying User Data Service
10. Deploying Sample Application
11. Using Sample Application
12. Post-Installation Checklist