Installing on the Second System

CA RiskMinder UNIX Installation Guide › Deploying RiskMinder on a Distributed System › Installing on the Second System

Installing on the Second System

After you install RiskMinder Server and Administration Console, install the other components on the second system in this distributed environment. The specific components to install must have been determined when you followed the instructions in Planning the Deployment.

Note: Before you proceed, ensure that all prerequisite software components are installed on this system as described in Preparing for Installation.

To install RiskMinder components on the second system:

Copy the installer file on the target (second) system:

For Solaris:

Arcot-RiskFort-3.1-Solaris-Installer.bin

For Linux:
```
Arcot-RiskFort-3.1-Linux-Installer.bin
```

Ensure that you have the permissions required to run the installer. If not, run the following command:
- For Solaris:
```
chmod a=rx Arcot-RiskFort-3.1-Solaris-Installer.bin
```
- For Linux:
```
chmod a=rx Arcot-RiskFort-3.1-Linux-Installer.bin
```

Run the installer as follows:

For Solaris:

prompt> sh Arcot-RiskFort-3.1-Solaris-Installer.bin

For Linux:

prompt> sh Arcot-RiskFort-3.1-Linux-Installer.bin

Follow the installer instructions from Step 6 in Installing on the First System until you reach the Choose Install Set screen.
Select the components that you want to install.
Typically, you install the Java SDKs for Risk Evaluation and Sample Application.
After you have selected all the components, follow Step 11 through Step 18 in Installing on the First System to complete the installation.