CA AuthMinder Windows Installation Guide › Upgrading to Release 7.1.01 › Upgrading to Release 7.1.01 › Reinstalling AuthMinder › Reinstalling AuthMinder on a Single System

Reinstalling AuthMinder on a Single System

To reinstall AuthMinder on a single system, perform the tasks described in the following sections:

Important! The information given in these sections apply to both a fresh installation of AuthMinder and an upgrade of an existing AuthMinder installation. Some of the steps mentioned in these sections do not apply in an upgrade scenario. For example, MySQL is supported only from release 7.1 onward.

Important! Use the database that you had migrated earlier during the upgrade operation. In addition, install AuthMinder at the same location where the older release was installed. If you install in a different location, the AuthMinder Server will not start.

1. Performing Complete Installation
2. Verifying the Database Setup
3. Preparing Your Application Server
4. Deploying Administration Console
5. Verifying the Administration Console
6. Starting AuthMinder Server
7. Verifying the Installation

   Note: If there are any warnings during Server startup or while verifying the installation, and if your transactions fail, then the upgrade has not been performed successfully. Use the information given in Troubleshooting Issues During Upgrade to fix any issues that you may encounter. If that does not help, revert to your initial setup by following the steps that are listed in Reverting to Your Initial Setup.

8. Deploying User Data Service
9. Deploying Sample Application
10. Using Sample Application
11. Performing Additional Configurations for CA Adapter 2.2.7
12. Post-Installation Checklist