A Packet Capture investigation performs a filtered capture of the particular server, application port, and network experiencing a problem.
When scheduling this investigation, the time zone you specify for the notification is also used to schedule the investigation.
Specify the following settings to launch or schedule a Packet Capture investigation:
Specifies the server you want to investigate.
Specifies the following options:
Specifies the application traffic you want to capture. To capture all application traffic on the target server, click All. To specify a custom port range, click Custom Application and specify the beginning and ending port numbers.
Specifies the client networks for which you want to capture the target application traffic.
Click All to specify all client networks or click Specific Network to specify a particular network, and then click the Network link to choose the network you want.
Specifies the following options:
Specifies the maximum time period, from 30 seconds to 30 minutes, to capture packets.
Specifies the maximum size, from 10 MB to 100 MB, for the packet capture file.
Specifies the number of bytes per packet to capture when capturing packets with a CA Standard Monitor. Choose between Header Only and 8192 bytes. Note that Header Only captures the MAC (Layer 2), IP (Layer 3), and TCP (Layer 4) header information.
This option is not applicable when the packets are captured by a NI GigaStor or CA Multi-Port Monitor.
Notifies the specified email recipients about the results of the investigation. Note that the investigation is scheduled using the specified time zone for the email notification.
The scheduling options only appear if you chose to schedule the investigation. Schedule the investigation to run at a particular time on a particular date or schedule the investigation on a weekly or monthly basis.
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|