Administration › Monitoring with Cisco WAAS › Troubleshoot a Cisco WAE Monitoring Device › Verify the Cisco WAE Configuration

Verify the Cisco WAE Configuration

Verify the Cisco WAE is:

• Optimizing the servers you want to monitor.
• The Cisco WAAS Flow Agent is exporting response time data for the optimized servers.

Follow these steps:

1. On the Cisco WAE, run the following command to show its optimized traffic:

   WAAS/WAE version 4.1.x

   show statistics connection all

   WAAS/WAE version 4.0.x

   show tfo connection summary

2. Review the list of server IP addresses and ports to make sure the Cisco WAE is optimizing the application traffic of interest.
3. Run the following command to view the list of servers for which Cisco WAAS Flow Agent is exporting response time data:

   show statistics flow filters
   

   If the list of servers does not match the list of optimized servers from the previous step:

   1. Verify the management console is monitoring the server.
   2. Verify the server is assigned to the application.
4. Click the link to synchronize monitoring devices with the current client network, server subnet, and application definitions on the management console.
5. Wait 5 minutes and then verify that the list of servers which the Cisco WAE is monitoring corresponds to the list of servers on the management console by running the following command:

   show statistics flow filters
   

   You should see that the server has now been added and the number of flow hits is greater than 0.

More information:

Manage Servers

Assign Servers to an Application