Disable Flow Monitoring on a Cisco WAE

To remove a Cisco WAE from the list of unassigned Cisco WAE monitoring devices, you must first disable flow monitoring on the Cisco WAE.

Follow these steps:

On the Cisco WAE, change to configuration mode by running the following command:
```
config
```
The command line prompt changes to:
```
WAE<config>#
```
Disable flow monitoring on the Cisco WAE by running the following command:
```
no flow monitor tcpstat-v1 enable
```
Return to privilege mode by running the following command:
```
exit
```
The command line prompt changes to:
```
WAE#
```
To confirm that flow monitoring is disabled, run the following command:
```
show statistics flow monitor tcpstat-v1
```
The results of the command confirm flow monitoring is disabled:
```
Flow application is not enabled or is not available.
```