Monitoring with Cisco WAAS › Add a Cisco WAE Monitoring Device › Configure the Cisco WAE to Export Response Time Data

Configure the Cisco WAE to Export Response Time Data

From the Cisco WAE CLI or Central Manager GUI, configure the Cisco WAE device to export application response time data.

Follow these steps:

1. On the Cisco WAE, change to configuration mode by running the following command:

   config
   

2. The command line prompt changes to:

   WAE<config>#
   

3. Disable flow monitoring on the Cisco WAE by running the following command:

   no flow monitor tcpstat-v1 enable
   

4. Register the Cisco WAE with the IP address of the management console by running the following command:

   flow monitor tcpstat-v1 host <MCAddress>
   

   Where <MCAddress> is the IP address of the management console.

5. Enable flow monitoring on the Cisco WAE by running the following command:

   flow monitor tcpstat-v1 enable
   

6. Return to privilege mode by running the following command:

   exit
   

7. The command line prompt changes to:

   WAE#
   

8. To confirm the Cisco WAAS Flow Agent is connected to the CA Application Delivery Analysis Manager, run the following command:

   show statistics flow monitor tcpstat-v1
   

   The results should indicate that the Configured Host Address is the IP address of the CA Application Delivery Analysis Manager. Note that it is normal for the Host Connection State to be Waiting to Poll except for when the Cisco WAE is polling the CA Application Delivery Analysis Manager.

9. Verify that the Cisco WAE appears in the list of WAN-optimization devices on the management console:
   1. Open the management console.
   2. Click the Administration page.
   3. Click Data Monitoring, Monitoring Devices in the Show Me menu.
   4. Scroll to the WAN Optimization Device List. If the Cisco WAE is displayed, you can assign the Cisco WAE to a CA Standard Monitor or CA Multi-Port Monitor.