Reason:
CA Allocate failed to obtain the data set name of the Disk Quota Table (DQT).
Action:
Verify that the data set named in the PLSDQTDS system parameter is a valid DQT. If it is not, and you do not already have a DQT, then allocate a new one. Use the JCL that you find in the ALLOCDQT member of the CCTVJCL target library in your SMP/E zone.
This error condition leaves a partially installed CA Allocate. Request a CLEANUP Operation to remove any remnants of the failed INSTALL Operation that were left loaded into system memory. Any RESIDENT=YES request, explicit or implied through PLSRES (Y), are ignored after this condition occurs.
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|