CA Advanced Authentication Upgrade Guide › CA Advanced Authentication Upgrading › How to Upgrade CA Risk Authentication on Windows › Reinstall CA Risk Authentication › How to Reinstall CA Risk Authentication on a Single System

How to Reinstall CA Risk Authentication on a Single System

Perform the tasks described in the following sections to reinstall CA Risk Authentication on a single system. Use the database that you had migrated earlier during the upgrade operation.

Important! The information applies to a fresh installation of CA Risk Authentication, Chapter: Deploy CA Risk Authentication on Single System, on Install CA Risk Authentication On Windows.

1. Install CA Risk Authentication.

   Note: While installing CA Risk Authentication, verify that you specify the same primary and backup database details from arcotcommon.ini in the %ARCOT_HOME%\conf\ directory\.

2. Verify the database setup.
3. Prepare the application server.
4. Deploy CA Advanced Authentication.
5. Log in to CA Advanced Authentication.

   Important! Ensure that you use the current MA password and not the default password, because the MA password has been reset during the bootstrap process that you performed during installation.

6. Start the CA Risk Authentication Server.
7. Start the Case Management Queuing Server.
8. Verify the installation.

   Note: If there is any warning during the Server startup and your transactions fails, then upgrade is not performed successfully. You can revert to your initial setup by following the steps listed in (In Error Scenario Only) Reverting to Your Initial Setup.

9. Deploy User Data Service.
10. Deploy Sample Applications.