CA Advanced Authentication Upgrade Guide › CA Advanced Authentication Upgrading › How to Upgrade CA Risk Authentication on Windows › Perform Post-Upgrade Tasks

Perform Post-Upgrade Tasks

This section describes the tasks that you must perform after upgrade.

Follow these steps:

1. If you disabled database replication before upgrade, you must enable replication for the backup database after upgrading to CA Risk Authentication 8.0 .
2. Verify the configuration of SSL with the following ports in CA Risk Authentication 2.2.7:
   • Port 7980 with Server Management protocol of the CA Risk Authentication Server instance
   • Port 7780 with Case Management Queuing Administration protocol of the Case Management Queuing Server instance
3. Reconfigure SSL by doing the the following steps:
   • Between CA Advanced Authentication and CA Risk Authentication Server: Port 7980
   • Between CA Advanced Authentication and Case Management Queuing Server: Port 7780

   Note: This configuration is required because most administrative tasks, such as instance management and protocol configuration, are done using these ports in CA Advanced Authentication in CA Risk Authentication 8.0.

   For the instructions on setting up SSL between CA Advanced Authentication and CA Risk Authentication Server or Case Management Queuing Server, see chapter, "Configuring SSL" in the CA CA Risk Authentication Administration Guide.

4. Set the Base Currency Code for your organization from the Miscellaneous Configurations screen.

   Note: For more information about setting the organization-specific base currency code, see chapter, "Managing Global Configurations" in the CA CA Risk Authentication Administration Guide.

5. If there are any rules with a score of 0 and you want to use these rules for scoring, then change the score to a nonzero value, like 1 or 2.