Previous Topic: Deploy Sample ApplicationNext Topic: How to Run a Silent Mode Installation

CA Strong Authentication UNIX Installation Guide › How to Deploy CA Strong Authentication on Distributed Systems › How to Deploy CA Strong Authentication on Additional Servers › Deploy Sample Application › Configure Sample Application Communication Server

Configure Sample Application Communication Server

If you installed the Sample Application and CA Strong Authentication Server on different systems, you must configure the communication settings.

Follow these steps:

Access the Sample Application in a Web browser window.

  1. In the navigation pane, click Setup -> Server Connectivity to open the CA Strong Authentication Server Connectivity page.
  2. Specify the values for the connection parameters that are listed in the following table:

    Note: The configurations that are made using these parameters are valid for the current session. Set these values again if you restart Sample Application or the application server.

Field

Default Value

Description

IP Address

localhost

The host name or the IP address where the CA Strong Authentication Server is available.

Port

9742

The port on which the Authentication and the Issuance service is available.

Maximum Active Connections

64

The maximum number of database connections maintained by the Sample Application.
  1. Click Set Up to save the connection.