CA Strong Authentication UNIX Installation Guide › How to Deploy CA Strong Authentication on a Single System › Post-Installation Tasks › Using webfortserver Utility

Using webfortserver Utility

The webfortserver tool enables you to check the release of CA Strong Authentication that you have installed. See the CA Strong Authentication Administration Guide for more information about this tool.

Follow these steps:

1. Navigate to the following location:

   <install_location>/arcot/bin
   

2. Run the following command to start the tool in interactive mode:

   ./webfortserver -i
   

3. Enter the version number at the prompt.

   The webfort-ver-<dd>-<mmm>-<yy>.txt file is created in the <install_location>/arcot/logs folder.

4. Open this file and check for the following lines to ensure that you are using the current version:
   • The version of CA Strong Authentication library files in the bin section is 8.0.
   • The version of the UDS library file (arwfuds.dll) in the bin section is 2.0.3.
5. Close the file.