Previous Topic: Configure Additional Properties in Full System EC2 ScenariosNext Topic: Restore Full Systems


Redirection Methods for Full System Scenarios

For Full System HA scenarios, Switch computer name and IP redirection are not supported; you may optionally choose DNS redirection. You can also customize the network resource to be used on the virtual machine. Specify the IP, gateway DNS and WINS address on the mapped NIC, if it uses static IP.

During Auto-Discovery, the software obtains the Master server IP address on the DNS server. If you set Redirect DNS to On, Arcserve RHA retrieves IP address of the switchover VM from the network mapping dialog.

Note: To turn ON redirection DNS in a reverse replication scenario when the active VM is on an Amazon EC2, manually enter the IP address that you want to update in the DNS on the replica server.

Running a Full System HA Scenario

When you start a Full System HA scenario, the software first validates the scenario configuration with a verification check. During synchronization, the data in protected volumes on the physical machine is replicated to a virtual disk file on the Replica. You can select the file, block volume, or offline synchronization. Volume synchronization is recommended for the initial synchronization because it performs better in LAN-based environments. However, since volume synchronization synchronizes all data from the Master to the Replica, the file or block level synchronization is recommended for any subsequent synchronizations since they offer a significant load reduction. For resynchronization, block level sync is used by default.

During replication, the software replicates all file system changes that occur on the physical machine to the Replica and applies those changes to the data on the virtual disk.

Operations on a Virtual Machine

You can use available operations to manage a virtual machine. These operations lets you start, stop, and delete all VM resources.

Start or Stop a Virtual Machine

Use this operation to start or stop a virtual machine from its latest system status or from a bookmark. You can start or stop a virtual machine after you create a scenario and synchronize the master and replica. Use this feature when the scenario is not running. This feature is available for Full System DR and HA scenarios. The Start/Stop is a toggle menu item.

Follow these steps:

  1. Click Tools, Start/Stop VM.

    The Set up the virtual machine dialog opens.

  2. Select a bookmark and an option to set the network for the newly created virtual machine.

    Consider the following points before you use this operation:

This operation creates and starts a new virtual machine on the appliance. Depending on the platform, virtual machine tools such as VMware tools, Integration Service, or XenServer tools are also installed on the virtual machine. Log in and check if data is accurate and various services are working.

Important! After the VM is started, do not use virtualization platform management tools (such as VMware vSphere Client, Hyper-V Manager, or XenCenter) to create a VM snapshot. This results in an unexpected error.

Delete Virtual Machine Resources

When you run a full system scenario, some temporary resources are created such as disk files, snapshots, and other files. This operation lets you delete these resources and is available when the scenario is not running.

Follow these steps:

  1. Click Tools, Delete all VM Resources.

    A warning appears that all protected data will be deleted.

  2. Select Yes to clean up all VM resources.

    Note: If the VM is already running, the operation shuts down the VM first and then removes all VM resources.

All created image as well as disk files and snapshots are deleted.