Reason
CA ACF2 for z/VM did not detect any end of the ARE entries flag before it found the end of the ARE buffer. The end of the ARE buffer is based on the length specified in the request control block. This is a programming error.
Action
If you were executing a CA ACF2 for z/VM‑supplied program or command, call CA Support. If you were executing a site‑written program, the most likely cause is a storage overlay of the ARE buffer. Correct the program and try again. If you still cannot solve the problem, call CA Support.
|
Copyright © 2009 CA Technologies.
All rights reserved.
|
|