Installation Procedure › Test System Installation Tasks › Maintenance ID Installation Steps › Step 6: Add CA ACF2 for z/VM Intercepts to CMS Modules

Step 6: Add CA ACF2 for z/VM Intercepts to CMS Modules

This step describes the procedures for adding CA ACF2 for z/VM intercepts to the CMS modules. CMS source files are required to do the assemblies.

Step 6 is starting.
Installing CA ACF2 for z/VM intercepts to CMS modules.
Enter GO to continue or ? for more information.

If you respond to this question with ?, you see the following information:

Step 6 adds CA ACF2 for z/VM intercepts to CMS and CMS/DOS modules.                      
                                                                                
This step performs the following functions:                                     
                                                                                
A. Uses the CMSRELnn ASMLIST file to determine which CMS                        
   modules can be assembled with CA ACF2 for z/VM intercepts.                            
   Where "nn" is  21 for Release 21 CMS
                  22 for Release 22 CMS
                  23 for Release 23 CMS
                  24 for Release 24 CMS
                  25 for Release 25 CMS
                  26 for Release 26 CMS
                  27 for Release 26 CMS

B. If you specified DOS = YES in step 1, it uses the                            
   CMSDOSnn ASMLIST file to determine which CMS/DOS modules                     
   can be assembled with CA ACF2 for z/VM intercepts.                                    
   Where "nn" is  21 for Release 21 CMS
                  22 for Release 22 CMS
                  23 for Release 23 CMS
                  24 for Release 24 CMS
                  25 for Release 25 CMS
                  26 for Release 26 CMS
                  27 for Release 26 CMS

C. Asks you which of the modules in task A and task B above are                 
   to be assembled.                                                             
                                                                                
D. Performs the assemblies based on your reply to task C.                       
   The minidisks with CMS maclibs must be accessible.                           
                                                                                
E. If it detects an error for any assembly, it prompts you for an               
   action to take.                                                              
                                                                                
                                                                                
Valid replies and their meanings are:                                           
                                                                                
  "GO" (or a null line)  to continue with the installation.                     
  "COMPLETE"  indicates you have completed all of the required                  
       functions this step performs. CA ACF2 for z/VM assumes that                       
       you have completed everything properly and continues to                  
       the next step.                                                           
  "HELP"  displays information on using this exec and                           
       valid replies for all prompts.                                           
                                                                                
Wait for a repeat of the prompt, then enter your reply.                         
Press ENTER when you are finished reading:

If you respond with GO, you see the following information:

This step uses the ACF2ASM EXEC to assemble CMS and CMS/DOS
modules with CA ACF2 for z/VM intercepts.
 
Before proceeding with these assemblies, you must access the
disks required to generate CMS, if you have not done so already.
 
Reply "CMS" to enter CMS commands.
Reply "EXIT" to leave this EXEC.
 
Press "ENTER" to continue.

The prompts that CA ACF2 for z/VM displays depend on your responses to previous questions.

Step 6 is complete.

Note: Remember to run VMFSETUP for CMS to access the CMS minidisks.