Installation Procedure › Test System Installation Tasks › Generate the Production System › Task M9C0P002: Perform Production MAINT Tasks

Task M9C0P002: Perform Production MAINT Tasks

This task lets you perform tasks that might be necessary to complete the migration to your production system.

To complete this task:

1. Select task M9C0P002 from the Task Selection Menu.

   You see the following panel:

   M9C0P002 Perform Production MAINT Tasks             CA ACF2 for z/VM
   ===>
   
   You may need to perform additional tasks from your MAINT userid
   to complete the migration to production. Evaluate the necessity
   of performing the following steps, and execute them if necessary using "ACF2TASK STEP n" (where "n" is step number below).
   
   ACF2TASK Description
   ‑‑‑‑‑‑‑‑ ‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑‑
   4        Generate the CP nucleus, IPL and update the VMO records.
   7        Generate the CMS nucleus with intercepts.
   8        Generate module files for various CMS commands.
   9        Finish the installation.
   
   Before starting ACF2TASK for production,         Access 3A0 R/W
   remember to access the correct production        Access 3A1 R/O
   disks as shown at the right:                     Access 3A3 R/O
   
   
                   Press PF2 to confirm this task.
   
   
   PF1=Help         2=Confirm       3=End       4=Return     5=          6=
   PF7=             8=              9=         10=          11=         12=
   

2. Access the specified disks and perform the necessary ACF2TASK steps.
3. Press PF2 to confirm that you want to perform this task. See the “Maintenance ID Installation Steps” section for information about performing these ACF2TASK steps.
4. When you have successfully completed all ACF2TASK steps, return to M9C0P002 and press PF2 to confirm the step is complete.

   A message appears on M9C0P002 confirming the action:

   M9C0P002 Perform MAINT Tasks                 CA ACF2 for z/VM 
   ===>
   Action confirmed;
   The remaining steps must be done from your MAINT userid because
   

5. Press PF3 to return to the Task Selection Menu.