Task M9C0I026: Set Up CMS Databases

Installation Procedure › Test System Installation Tasks › Task M9C0I026: Set Up CMS Databases

Task M9C0I026: Set Up CMS Databases

This task sets up the CA ACF2 for z/VM CMS databases. The primary @DDSN macro in the ACFFDR specifies one or more CMS databases. You must set up the service machine CMS databases. See the Administrator Guide for information about the post backup service machine.

Each database requires an entire minidisk. Task M9C0I011 defined these minidisks and task M9C0I014 formatted them.

If you are a new CA ACF2 for z/VM site, load the supplied sample databases to set up your CMS databases. If you already have CMS databases, bypass this task.

To complete this task:

Select task M9C0I026 from the Task Selection Menu.

The following panel appears:

M9C0I026 Set Up CMS Databases CA ACF2 for z/VM ====> This step sets up the CA ACF2 for z/VM CMS databases. Enter "S" to load the sample CMS databases: _ Press PF2 to perform this task: Press PF5 to bypass this task: PF1=Help 2=Perform 3=End 4=Return 5=Bypass 6= PF7= 8= 9= 10= 11= 12=

Press PF5 to bypass setting up the CMS databases or PF2 to set up the CA ACF2 for z/VM CMS databases.
If you press PF5, a message appears on the panel confirming that you are bypassing this step:
```
M9C0I026      Set Up CMS Databases                 CA ACF2 for z/VM 
 ===>
 CMS database setup has been bypassed. Press PF3 to exit.
```
If you press PF2, a message appears on the above panel when processing is complete confirming that the CMS database is set:
```
M9C0I026      Set Up CMS Databases                CA ACF2 for z/VM 
 ===>
 CMS database setup complete;
```
Press PF3 to return to the Task Selection Menu.