Running ACF2PSMF

Below is the syntax of the command to run this utility:


ACF2PSMF      [ ARCHIVE { YES}] [ VOLSER { volser }]
              [         { NO }] [        { XXXXXX }]
 
              [[ TDISK { NO                  }] [ WORKDISK{ vaddr } ]]
              [[       { type #_of_cylinders }] [         { NO    } ]]

You should be aware of the following information regarding the previous syntax:

You can only use the VOLSER option when you specify ARCHIVE YES.
TDISK and WORKDISK are mutually exclusive.
You only need the TDISK and WORKDISK options if your site is running with FDR @SMF option SWITCH=DUMP.
You can substitute WORKDISK for TDISK.

ARCHIVE {YES|NO}

Specifies ARCHIVE processing.

YES

Copies the SMF data to tape. ACF2PSMF creates a standard labeled tape with a label of SMF.Yyy.Dddd.Ssss; where Y, D, and S are constants.

yy: Last two digits of the current year.
ddd: Julian day the file was created.
sss: Sequence number of the file.
NO: Does not do ARCHIVE processing (the default).

VOLSER volser

Put this volume serial number on the tape. The VOLSER parameter can be up to six bytes long. The default VOLSER is XXXXXX.

TDISK {NO|type #_of_cylinders}

Specifies the TDISK processing.

NO: Do not use TDISK for work space.
type: The DASD type of the TDISK. Restricts TDISK type to any valid DASD type that CP recognizes.
#_of_cylinders: The amount of space of TDISK to define.

WORKDISK{vaddr|NO}

One of the following:

NO: Do not use WORKDISK.

vaddr

Use this disk for workspace. The virtual address specified in this parameter must be a CMS‑formatted minidisk.