Using the Model Setting › Creating a Model › Activate Command Limiting

Activate Command Limiting

Your command model is almost ready to use. But before going into production, you should perform the following steps:

• Modify the command limiting rule to perform as needed.
• Use the test exec to ensure that the rule is performing as expected.
• Compile the model under the current MDLTYPE. To determine the MDLTYPE, display the CMDLIM VMO record or issue the ACF SHOW CMDLIM command.
• Compile the rule under the current MDLTYPE.
• Change the CMDLIM VMO record to limit your command.
• Delete the test model and rule you created earlier.