The ACFMOUNT command lets you access a tape volume. The syntax for the ACFMOUNT command is:
ACFMOUNT volser [vadr access]
The parameters for the ACFMOUNT command are defined below.
Represents the one‑ to six‑alphanumeric character volume serial identification of the mounted tape. You must issue this parameter. There is no default.
Represents the virtual device address of the tape drive where the tape is mounted. If you specify this parameter and CA ACF2 for VM grants access to the requested tape volume after performing validation, CA ACF2 for VM informs the operator to mount the tape on the tape drive's real device address. If you omit this parameter and CA ACF2 for VM grants access to the requested tape volume after performing validation, CA ACF2 for VM tells the operator to mount the tape without specifying the device. This parameter is optional. There is no default.
Indicates the optional requested operation to be performed, READ (the default) or WRITE. You cannot abbreviate this parameter.
|
Copyright © 2009 CA Technologies.
All rights reserved.
|
|