The CA 3Tera AppLogic dashboard is the primary interface to a grid. It displays the hardware configuration and the current status of the grid, shows how many applications are currently running and how much resources are allocated to them, displays the list of currently installed applications and allows you to create, configure and manage applications.
To access your grid's dashboard page using GUI
Note: The gridname is most likely your company's name.
The prompt to enter your user name and password appears.
If you are logging in for the first time, the License Agreement page appears followed by the grid's dashboard page. Else, the grid's dashboard page appears.
Grid Dashboard
The grid dashboard contains the following important information and state about your grid:
Shows the current status of your grid, the number of physical servers and number of applications running on the grid. The Refresh button updates this information.
Shows important messages from the CA 3Tera AppLogic service (core grid) -- regarding the core grid and your grid. To refresh this information, refresh the page in your browser.
Shows configuration information about your grid: IP address of the grid controller, number and type of servers, and the list of IP addresses that you can use in applications running on the grid. Other network settings, such as the netmask, gateway address and DNS servers are either listed there or in the message board.
The visual interface gives you access to the applications and appliances installed on the grid.
To access the CA 3Tera AppLogic visual interface, click on the Applications tab from the grid dashboard page. You should see the list of installed applications on your grid.
|
Copyright © 2011 CA.
All rights reserved.
|
|