Troubleshooting › Source Generation Errors › Context Not Found

Context Not Found

Problem: Context Not Found occurs if:

• You changed the access paths on a function and did not revisit the action diagram to re-verify user statements.
• You removed function fields from the device design and did not revisit the action diagram to re-verify user statements.
• You changed parameters on called functions and did not revisit the action diagram containing the call to re-verify the parameters.
• You copied sections of code between user points or between action diagrams containing contexts that are not valid at the target.

Solution: Use the Find Error facility in the action diagram editor, or find the errors by looking for ??? in the source listing. You can roll backward to identify both the function that is called and the user point in which the function is located.

When you revisit the parameters for a statement or a function, always prompt the field and reselect the values.CA 2E does not automatically perform the validation on the statement shown if you do not make a change to the displayed parameter values.