Utility Report Messages › Health Check Messages › TMSH0062E

TMSH0062E

The health check has terminated before the end of the DSNB was reached. This was caused by an error in the DSNB chain. Run TMSAPEC to identify and correct the DSNB chain error. Rerun this health check after TMSAPEC has been run. Program stopped at DSNB xxxx when the last DSNB in the chain is yyyy.

Reason:

The health check continues to run until it reaches the end of the DSNB chain. This error message is issued when the health check stops before the last DSNB has been read.

Action:

This message is issued by the CA 1 Health Check component, which provides extensive detail on the problem and the suggested response. The following actions and responses are documented for this check:

System Action: Automatically correct the DSNB chain error by running TMSAPEC.

Operator Response: Notify the CA 1 tape administrator of this condition.

System Programmer Response: Automatically correct the DSNB chain error by running TMSAPEC. Then rerun this health check.

Problem Determination: DSNB chain error has been detected. Run TMSAPEC to correct the error.

Source: CA 1 Tape Management System

Reference Documentation: CA 1 Tape Management Administration Guide