Reason:
This abend is uniquely associated with TMSXTEND. The exact reason for the failure is documented in the reason code in register 15.
|
Code |
Reason |
Action |
|---|---|---|
|
01 |
TMS OPEN FAILED.TMSXTEND was unable to open the TMC for SVC access. |
Verify that the active TMC on the system where TMSBLDVR is a valid TMC. |
|
02 |
The user responded to a console message telling TMSXTEND to abend because the list of systems impacted by this extend was not correct. |
Correct the CPU table (CPULIST DD) to include the correct systems that should be impacted by this extend. Rerun TMSXTEND. |
|
03 |
CTL#4 CPU flag has been corrupted. |
Reformat the audit. |
|
05 |
SIGNAL ECB NOT ZERO |
TMSBLDVR did not post the signal ECB with a zero. This would indicate a problem and TMSXTEND is NOT to signal other CPU's to access the new TMC. |
|
06 |
TMSAUDEX NON-ZERO COMPLETION |
SubtAask did not end normally. See output from TMSAUDEX. |
|
07 |
TMSBLDVR NON-ZERO COMPLETION |
Subtask did not end normally. See output from TMSBLDVR. |
|
0F |
RNAME ERROR FOR CPU IN CTL#4 |
Verify all CPUs support Unique RNAME functionality. |
|
1D |
TMC.N ----> TMC.O ----> TMC.N |
The rename failed, see the IDCAMS error messages in the SYSPRINT output. |
|
1E |
TMC ----> TMC.O |
The rename failed, see message TMSXT30I. |
|
1F |
TMC.N ----> TMC |
The rename failed, see message TMSXT31I. |
|
2B |
TMC.O ----> TMC |
The rename failed, see message TMSXT43I. |
|
33 |
CTSDIO ERROR ON NEW TMC. |
See message TMSXT51I. |
|
38 |
BAD ACTIVITY FROM NON-RESP CPU. |
See message TMSXT56E. |
|
3B |
CPU(S) CAN NOT ACCESS NEW TMC. |
See messages TMSXT59E and/or TMSXT14E. |
|
3C |
TMC DSN IS TOO LONG. |
See message TMSXT60E. |
|
3D |
VOLSER UPDATE ERROR. |
See message TMSXT61E. |
|
3E |
DSNB UPDATE ERROR. |
See message TMSXT62E. |
|
3F |
MUTUALLY EXCLUSIVE PARMS. |
See message TMSXT63E |
|
40 |
INVALID CPU DURING SYNC. |
See msg. TMSXT64E. |
|
41 |
UPDATE WITH BAD BATCH-ID. |
See message TMSXT65E. |
|
42 |
TMC BACKUP > 3HRS OLD. |
See message TMSXT66E. |
|
52 |
EXTEND ALREADY ACTIVE. |
See message TMSXT82E |
|
54 |
NO EXTEND STATUS RECOVER NOT REQ. |
See message TMSXT84E. |
|
55 |
TMEXTEND FLAG RESET WHILE EXTEND PROCESSING. |
The extend flag in the AUDIT file was set to zero after TMSXTEND started processing. |
|
Copyright © 2013 CA Technologies.
All rights reserved.
|
|