01

Invalid DATEFMT parameter.

Correct the DATEFMT parameter and resubmit the job.

02

CA 1 is not batch active.

CA 1 must be batch active to perform an EXTEND operation on the TMC. For instructions on using TMSINIT to make CA 1 batch active see the Utilities and Reports Reference Guide.

03

An invalid volume serial number not in the TMC was encountered during TMSFORMT processing.

Check the TMSFORMT output listings for other associated error messages. If either TMSXITU or TMSXITE has been changed, review these changes and correct the logic.

04

The number of DSNBs in RESTORE Control Record 2 does not agree with the number of DSNBs read.

Execute TMSPTRS to identify the errors causing the problem. After correction, resubmit.

05

A FORMAT operation was requested without PARM=NEW being specified and CA 1 is not active.

Either add the PARM=NEW parameter to FORMAT the TMC with CA 1 inactive, or activate CA 1 before resubmitting your job.

06

A reply of END was entered in response to the IEFTMS62 WTOR message.

If the job is to be rerun, correct the TMC dsname and resubmit the job, otherwise no action is needed.

07

TMSFORMT is being used to add a range to a TMC that is in the extended format.

Use TMSXTEND to add a volume range to the TMC.