104

The data set indicated (TMC or Audit) could not be located in the system catalog.

Catalog the data set. CA 1 cannot initialize unless both the TMC and Audit data sets are cataloged.

108

The data set indicated (TMC or Audit) is a multivolume data set.

Reallocate the data set. Existing TMCs should be moved (see the Programming Guide). New TMCs can be reformatted to a single volume. The Audit data set can be reformatted and reblocked to a single volume.

112

The DSCB for the data set indicated (TMC or Audit) is not in the VTOC of the volume pointed to by the MVS catalog.

Locate the data set and point the MVS catalog entry to the correct volume. Verify that the device for the TMC and AUDIT are online.

116

The data set indicated (TMC or Audit) is allocated to more than three extents and a second DSCB could not be found.

This is typically a result of the VTOC on the device in question having been zapped. Since CA 1 does not perform standard OPENs, but uses EXCPs to relative track addresses for the bulk of this I/O, damage to the VTOC entry (a missing format 3 DSCB in this case) can cause this problem. If the data set is new, it can be reallocated and reformatted with TMSFORMT. If it is a production TMC, follow the procedures for restoring the TMC with TMSCOPY. If it is a production Audit, simply reallocate and reformat with TMSFORMT.

120

The UCB for the data set indicated (TMC or Audit) could not be found.

Ensure the catalog entries for the TMC or Audit data set are correct.

124

The data set indicated (TMC or Audit) is located on a device that is not supported by CA 1

See any maintenance documents that provide support for that device. For assistance, contact Technical Support at http://ca.com/support.

128

The UCB for the data set indicated (TMC or Audit) was above the 16m line.

Ensure the data set is allocated to a UCB below 16m.

132

The data set indicated (TMC or Audit) does not have the correct record size.

Verify that the correct data set name was specified in the options member (TMOOPTxx) used. If the data set name specified was incorrect, change the option and rerun TMSINIT. If the data set name specified was correct, the TMC or Audit needs to be reformatted to the correct size using the procedures documented for TMSFORMT in the Utilities and Reports Reference Guide.