CA 1 can only be activated by executing the TMSINIT batch utility. Run the CAS9/CAIRIM initialization procedure before TMSINIT. CAIRIM initialization for CA 1 must complete successfully for TMSINIT to execute properly. During initialization, you receive the IEFTMS0 message through a WTOR. The normal response to this message is U to activate CA 1. Other acceptable responses are listed on the console when HELP is replied to the IEFTMS0 WTOR.
Depending on when TMSINIT was last executed, and the selected options, you can receive other date verification messages.
Note: For more information about the console messages, see the Message Reference Guide.
Responses to TMSINIT are eliminated by using the JCL parameter NODATE. Using this parameter automatically places CA 1 in an active state and uses the system date as the current date.
After the first TMSINIT is executed at system IPL, a security call is made. The call validates that the user submitting TMSINIT, or the console operator if TMSINIT is executed as a started task, is authorized to reinitialize, batch activate, or deactivate CA 1.
Initialize CA 1 by entering START TMSINIT through the console at IPL time, or through the CAUTOCMD member of hlq.CTAPOPTN for automated startup following CAIRIM initialization. Once CA 1 is initialized, TMSINIT terminates. TMSINIT does not stay active as a task.
Do not execute TMSINIT while TMSCLEAN, TMSCYCLE, TMSCTLG, TMSEXPDT, or TMSXTEND is running.
|
Copyright © 2013 CA Technologies.
All rights reserved.
|
|