ISPF Customization Steps

ISPF Customization Panels › ISPF Customization Steps

ISPF Customization Steps

Perform the following steps to complete the ISPF Customization Process.

Type the Following Command in ISPF option 6:
```
EXEC 'HLQ.CCUUEXEC(OSINSTAL)'
```

Enter d to Define a New CA Vtape System on the Option line as follows, and press Enter.

The following is an example of the main menu.

OSIP0000 ------------- CA Vtape Virtual Tape System ----------------- SUTPARMS Generator Option ===> CCCCCCCCCCCCCC CCC CCC CCC AAAA VV VV TTTTTTTTTT AA PPPPPP EEEEEEE CCC AAAAAA VV VV TT AAAA PP PP EE CCC AAA AAA VV VV TT AA AA PP PP EE CCC AAA AAA VV VV TT AAAAAAAA PPPPPP EEEEE CCCCCCCCCCCAAA VV VV TT AA AA PP EE AAA AAA VVVV TT AA AA PP EE AAA AAA VV TT AA AA PP EEEEEEE AAA AAA AAA AAA PF3 to Exit R Regenerate the SUTPARMS configuration member D Define a new SUTPARMS configuration member Enter END command to terminate session.

Enter the PREFIX.SVTJCL library data set name allocated with the VTA08NON job. The default SVTJCL data set name is shown. Enter c on the command line and press Enter to continue to the next panel.

DISP1000 --------------- CA Vtape Virtual Tape System ---------------- SUTPARMS Generator

COMMAND ===> c C to Continue PF3 to Previous Specify the SVTJCL Data Set Name (Prefix.SVTJCL) SVTJCL Library: CAVTAPE1.SVTJCL____________________________ The SVTJCL data set is the repository for the generated SUTPARMS configuration member. The data set was allocated by customizing and executing member VTA08NON in the CCUUJCL data set. ***

Enter the CA Vtape DSN Prefix. The default value is CAVTAPE1. Enter g on the command line and press Enter to generate the SUTPARMS configuration member.

Note: This is the value that will be used by CA Vtape to dynamically create and catalog work data sets. This value must match the catalog alias you defined earlier in the chapter "System Setup Chapter."

OSIP130D --------------- CA Vtape Virtual Tape System ---------------- SUTPARMS Generator COMMAND ===> g G to Generate Session Mode: Define PF3 to Previous The Data Set Name Prefix is used to define CA Vtape System Data Sets. A maximum of 23-characters can be entered. System DSN Prefix: CAVTAPE1_______________ CA Vtape System Data Sets: * Prefix.VVE.Ddevn.sysname Virtual Device Work Data Sets * Prefix.VVE.VDATAQ.sysname.subsysnm Work Save Data Sets * Prefix.VVE.Ddate.Ttime.LIBn Tasklib Loadlib ***

When the generation process is complete, you will be placed in a browse session to review the generated SUTPARMS configuration member.

Press PF3 to return to the Main Menu. Press PF3 again to leave the Customization Panels or enter a d to correct the DSN Prefix.