Error 15047

Not enough memory to continue, [number]

Module:

Data Multiplexing

Reason:

The host server does not have enough memory to run the job as submitted. The job can not continue. The [number] is the memory space requested in bytes.

Action:

To address this error message, perform the following:

• Use a smaller Data Multiplexing buffer (you can configure this buffer in the BrightStor ARCserve Backup Schedule console under Configure BrightStor ARCserve Backup Server).
• Add more memory to the server.
• Set the Garbage Collection Interval of the host server to a shorter period.
• Check the server memory. To do so, follow these steps:
  1. Enter LOAD MONITOR from the server console.
  2. Select Resource Utilization from the Available Options menu.
  3. If the cache buffer percentage is very low (below 30%), your server is probably low on memory.
  4. To free memory, unload any NLMs that are not required.
  5. Enter ASTOP from the server console to stop BrightStor ARCserve Backup.
  6. Enter ASTART from the server console to restart BrightStor ARCserve Backup.
• If you receive this error again, restart the file server.