Reference Guide › AutoShell › AutoShell Loadable Modules' Command Reference › CA VMware vCenter Server AutoShell Commands › dpmvc-imgjobcheck Command--Get Clone Job Status (Funclet)

Previous Topic: dpmvc-getsnapshots Command--List Snapshots of a VM (Funclet)

Next Topic: dpmvc-migrate Command--Migrate a VM (Funclet)
dpmvc-imgjobcheck Command--Get Clone Job Status (Funclet)

The dpmvc-imgjobcheck command obtains the cloning job status for a specific CA Virtual Assurance job ID or a specific vCenter task ID. The job ID is provided for certain dpmvc commands. Use this command to check the status on vCenter.

This command has the following format:

dpmvc-imgjobcheck 
-status job ID 
[-vc vcenterservername]
-status jobID

Specifies the job ID used to obtain the job status.

-vc vcenterservername

Specifies the vCenter Server where the VM is located.

Example: Get the Cloning Job Status Using the Job ID in a Single vCenter Server Environment

This example obtains the cloning job status using a CA Virtual Assurance job ID.

dpmvc-imgjobcheck -status 42