Installing Your Product from Tape › How to Install Products Using Native SMP/E JCL › Prepare the SMP/E Environment for Tape Installation

Prepare the SMP/E Environment for Tape Installation

The members used in this procedure prepare the data sets, initialize the zones, and create the DDDEFs for CA Tape Encryption.

For information about the members, see the comments in the JCL.

To prepare the SMP/E environment for your product

1. Customize the macro TBESEDIT with your site-specific information and then copy the macro to your SYSPROC location. Replace the rightmost parameters for each ISREDIT CHANGE macro command. Each time you edit an installation member, type TBESEDIT on the TSO command line, and press Enter to replace the defaults with your specifications.

   The macro is ready to customize your TBE.SAMPJCL members.

   Note: The following steps include instructions to execute the TBESEDIT macro each time you open a new SAMPJCL member. To edit all SAMPJCL members simultaneously, read and follow the instructions in the TBEEDALL member.

2. Open the SAMPJCL member TBE1ALL in an edit session and execute the TBESEDIT macro from the command line.

   TBE1ALL is customized.

3. Submit TBE1ALL.

   This job produces the following results:

   • The target and distribution data sets for CA Tape Encryption are created.
   • Unique SMPLTS, SMPMTS, SMPSCDS, and SMPSTS data sets for this target zone are created.
4. Open the SAMPJCL member TBE2CSI in an edit session and execute the TBESEDIT macro from the command line.

   TBE2CSI is customized.

5. Submit TBE2CSI.

   This job produces the following results:

   • The CSI data set is defined.
   • The SMPPTS and SMPLOG data sets are allocated.
   • The global, target, and distribution zones are initialized.
   • The DDDEF entries for your product are created.
   • The DDDEFs for the required SMP/E data sets are created.