Performing Recovery Operations › Starting BES on a Disaster Recovery Floor System

Starting BES on a Disaster Recovery Floor System

CA Common Services must be started before starting BES. If this does not occur, the BES started task abends with an S122 operator cancel at the point in the start up where the BES LMP key is validated.

If CA 1 or CA TLMS Tape Management Systems are installed at the home site and are not installed on the floor system, add the CTAPLINK to the LNKLST or to the BES PROC STEPLIB DD. If neither of these actions are taken, the BES started task abends with a S806 for the G8UTY load module.

If CA 1 or CA TLMS Tape Management Systems will not be started on the floor system, add the CTAPLINK to the LNKLST or to the BES PROC STEPLIB DD. If neither of these actions are taken, the BES started task will experience an S806 abend for the CAILPAM load module immediately after you reply no to the BESnI0053Q WTOR.